Rohde & Schwarz RTE - Page 1611

Remote control commands
R&S
®
RTE
1611User Manual 1326.1032.02 ─ 20
TRIGger<m>:MILStd:DATA:RCONdition <RTAOperator>
TRIGger<m>:MILStd:CMD:RCONdition <RTAOperator>
TRIGger<m>:MILStd:CDST:RCONdition <RTAOperator>
Sets the operator to define a remote terminal address:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one pattern to
be set with TRIGger<m>:MILStd:CDST:RMIN.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:MILStd:CDST:RMIN and
TRIGger<m>:MILStd:CDST:RMAX.
*RST: EQUal
TRIGger<m>:MILStd:DATA:RMIN <RTAPatternMin>
TRIGger<m>:MILStd:CMD:RMIN <RTAPatternMin>
TRIGger<m>:MILStd:CDST:RMIN <RTAPatternMin>
Specify a remote terminal address or set the the start value of a remote terminal
address range:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Parameters:
<RTAPatternMin> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
TRIGger<m>:MILStd:DATA:RMAX <RTAPatternMax>
TRIGger<m>:MILStd:CMD:RMAX <RTAPatternMax>
TRIGger<m>:MILStd:CDST:RMAX <RTAPatternMax>
Set the end value of a data range if TRIGger<m>:MILStd:CDST:RCONdition is set
to INRange or OORange:
●
DATA: for data words
●
CMD: for command words
●
CDST: for status words
Protocols