Rohde & Schwarz RTE - Page 1628

Remote control commands
R&S
®
RTE
1628User Manual 1326.1032.02 ─ 20
Parameters:
<DataIndexMax> Range: 1 to 32
Increment: 1
*RST: 32
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MILStd:CMD:TR <SearchName>,<TRFlag>
SEARch:TRIGger:MILStd:CMD:TR? <SearchName>
Searches for a transmission mode.
Parameters:
<TRFlag> ONE | ZERO | DC
*RST: DC
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MILStd:ERRor:MANChester <SearchName>,<ManCodingError>
SEARch:TRIGger:MILStd:ERRor:MANChester? <SearchName>
SEARch:TRIGger:MILStd:ERRor:PARity <SearchName>,<ParityError>
SEARch:TRIGger:MILStd:ERRor:PARity? <SearchName>
SEARch:TRIGger:MILStd:ERRor:SYNC <SearchName>,<SyncError>
SEARch:TRIGger:MILStd:ERRor:SYNC? <SearchName>
SEARch:TRIGger:MILStd:ERRor:TIMing <SearchName>,<MinGapSelect>
SEARch:TRIGger:MILStd:ERRor:TIMing? <SearchName>
Enables search for errors if SEARch:TRIGger:MILStd:TYPE is set to ERRor.
●
MANChester: error of the manchester coding
●
PARity: even parity (parity error)
●
SYNC: error of the synchronization
●
TIMing: Minimum gap is out of range
Parameters:
<SyncError>,
<ParityError>,
<ManCodingError>,
<MinGapSelect>
ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:MILStd:STATus:BCReceived <SearchName>,<BroadcastCmd>
SEARch:TRIGger:MILStd:STATus:BCReceived? <SearchName>
SEARch:TRIGger:MILStd:STATus:BUSY <SearchName>,<BusyFlag>
SEARch:TRIGger:MILStd:STATus:BUSY? <SearchName>
Protocols