Rohde & Schwarz RTE - Page 1677

Remote control commands
R&S
®
RTE
1677User Manual 1326.1032.02 ─ 20
STARt
Start of frame.
MAC
MAC frame. This frame contains information that define how to
go about transmitting and receiving frames.
IDLE
IDLE frame. This frame is used for clock synchronization.
ERRor
Error frame. Thi frame contains erroneous bits.
*RST: STARt
TRIGger<m>:HBTO:DADDress:CONDition
<DestAddrOptor>
Sets the condition for the destination address. You can define an exact value or a value
range.
Suffix:
<m>
.
1..3
Parameters:
<DestAddrOptor> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding TRIGger<m>:HBTO:
DADDress:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with TRIGger<m>:HBTO:DADDress:MIN and
TRIGger<m>:HBTO:DADDress:MAX.
*RST:
EQUal
TRIGger<m>:HBTO:DADDress:MIN <DestAddrPattMin>
Specifies the destination address bit pattern, or sets the start value of a pattern range.
Suffix:
<m>
.
1..3
Parameters:
<DestAddrPattMin> Numeric or string pattern, see Chapter 18.4.6, "Bit pattern
parameter", on page 1076. The string parameter accepts the bit
value X (don't care).
Protocols