Rohde & Schwarz RTE - Page 1799

Remote control commands
R&S
®
RTE
1799User Manual 1326.1032.02 ─ 20
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one endpoint
value to be set using TRIGger<m>:USB:EMIN.
INRange | OORange
In range, out of range. These conditions require a range of end-
point values to be set using TRIGger<m>:USB:EMIN and
TRIGger<m>:USB:EMAX.
*RST: OFF
TRIGger<m>:USB:EMIN
<Endp>
Specifies the endpoint, or sets the the start value of an endpoint range.
Parameters:
<Endp>
TRIGger<m>:USB:EMAX <EndpTo>
Sets the the end value of an endpoint range if TRIGger<m>:USB:ECONdition is set
to INRange or OORange.
Parameters:
<EndpTo>
TRIGger<m>:USB:ERRC <ErrorType>
Sets the trigger to an error condition type.
Parameters:
<ErrorType> ANY | PIDerror | CRC5error | CRC16error | BTST | UNEXpid |
SE1error | GLITcherr
ANY
Triggers on any of the errors listed below.
PIDerror
Triggers on any packet identifier error.
CRC5error
Triggers on any CRC5 error event.
CRC16error
Triggers on any CRC16 error event.
BTST
Triggers on any bitstuffing error event (erroneous or missing bit
stuffing sequence, see USB standard).
UNEXpid
Triggers on any unexpected PID error (illegal PID, that is not
allowed in USB low speed and USB full speed protocols, espe-
cially PID's announcing packets such as SPLIT, DATA2, MDATA,
or other noncompliant packets).
Protocols