Remote control commands
R&S
®
RTE
1803User Manual 1326.1032.02 ─ 20
PREamble
Sets the trigger to the PREamble PID
ERR
Sets the trigger to the ERRor PID
SPLit
Sets the trigger to the SPLIT PID (in USB high speed transac-
tions)
PING
Sets the trigger to the PING PID (in USB high speed transac-
tions, flow control probe for a bulk/control endpoint)
*RST: PREamble
TRIGger<m>:USB:STCO
<SC>
Sets the trigger to a specific start-split or complete-split transaction endpoint.
Parameters:
<SC> ONE | ZERO | DC
ONE
SC = 1 represents a complete-split (CSPLIT) transaction.
ZERO
SC = 0 represents a start-split (SSPLIT) transaction.
DC
SC = X represents "don't care" (DC)
*RST: DC
TRIGger<m>:USB:TCONdition <OperatorET>
Sets the operator to set a specific endpoint type (ET) or an ET range. The ET values
are set with TRIGger<m>:USB:TMIN and TRIGger<m>:USB:TMAX.
Parameters:
<OperatorET> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
OFF = ANY
The position of the endpoint type is not relevant.
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one ET value to
be set using TRIGger<m>:USB:TMIN.
INRange | OORange
In range, out of range. These conditions require a range of ET
values to be set using TRIGger<m>:USB:SMIN and
TRIGger<m>:USB:SMAX.
*RST:
OFF
Protocols
To Next Page
Loading...
