Rohde & Schwarz RTE - Page 1818

Remote control commands
R&S
®
RTE
1818User Manual 1326.1032.02 ─ 20
Parameters:
<HandshakeType> ANY | ACK | NAK | STALl | NYET
*RST: ACK
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:PATT <SearchName>,<PayloadMuster>
SEARch:TRIGger:USB:PATT? <SearchName>
Defines the payload data pattern to search for.
Parameters:
<PayloadMuster>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:PCONdition
<SearchName>,<OperatorPort>
SEARch:TRIGger:USB:PCONdition? <SearchName>
Sets the operator to set a specific port number or a port number range. The port num-
ber values are set with SEARch:TRIGger:USB:PMIN and SEARch:TRIGger:USB:
PMAX.
Parameters:
<OperatorPort> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one port number
to be set using SEARch:TRIGger:USB:PMIN.
INRange | OORange
In range, out of range. These conditions require a port number
range to be set using SEARch:TRIGger:USB:PMIN and
SEARch:TRIGger:USB:PMAX.
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:PMIN <SearchName>,<Port>
SEARch:TRIGger:USB:PMIN? <SearchName>
Specifies a port number, or sets the start value of a port number range.
Parameters:
<Port>
Parameters for setting and query:
<SearchName>
Protocols