Rohde & Schwarz RTE - Page 1819

Remote control commands
R&S
®
RTE
1819User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:USB:PMAX <SearchName>,<PortTo>
SEARch:TRIGger:USB:PMAX? <SearchName>
Sets the the end value of a port number range if TRIGger<m>:USB:PCONdition is
set to INRange or OORange.
Parameters:
<PortTo>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:PIDerror <SearchName>,<PIDError>
SEARch:TRIGger:USB:PIDerror? <SearchName>
Defines, whether a search for any PID error shall be activated or not.
Parameters:
<PIDError> ON | OFF
*RST: OFF
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:USB:SCONdition <SearchName>,<OperatorSEU>
SEARch:TRIGger:USB:SCONdition? <SearchName>
Sets the operator to set a specific SEU or an SEU range. The SEU values are set with
SEARch:TRIGger:USB:SMIN and SEARch:TRIGger:USB:SMAX.
For SEU, see "SEU" on page 834.
Parameters:
<OperatorSEU> OFF | ANY | EQUal | NEQual | LTHan | LETHan | GTHan |
GETHan | INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less than or equal, Greater than,
Greater than or equal. These conditions require one SEU value
to be set using SEARch:TRIGger:USB:SMIN.
INRange | OORange
In range, out of range. These conditions require a range of SEU
values to be set using SEARch:TRIGger:USB:SMIN and
SEARch:TRIGger:USB:SMAX.
*RST: OFF
Parameters for setting and query:
<SearchName>
Protocols