Rohde & Schwarz RTE - Page 834

Protocol analysis
R&S
®
RTE
834User Manual 1326.1032.02 ─ 20
TRIGger<m>:USB:FMIN on page 1800
TRIGger<m>:USB:FMAX on page 1800
SC check
Defines, whether a Start / Complete SPLIT transaction check is executed or not.
Remote command:
TRIGger<m>:USB:WSTC on page 1806
TRIGger<m>:USB:STCO on page 1803
Port
Defines, whether a port check that meets specific conditions is executed or not.
"Condition"
Defining a specific port number or a port number range requires to
set the operator to one of the following: equal, not equal, less than,
less than or equal, greater than, greater than or equal, in range, out
of range.
"Min"
Specifies a port number, or sets the start value of a port number
range.
"Max"
Sets the end value of a port number range if "Condition"
(TRIGger<m>:USB:PCONdition) is set to INRange or OORange.
Remote command:
TRIGger<m>:USB:WPOR on page 1805
TRIGger<m>:USB:PCONdition on page 1801
TRIGger<m>:USB:PMIN on page 1801
TRIGger<m>:USB:PMAX on page 1802
SEU
Defines, whether an SEU check that meets specific conditions is executed or not. S
and E represent the Start and End of a start-split transaction, U represents the
reserved/Unused bit of a complete-split transaction. Permissible binary SEU values are
00, 01, 10, and 11.
"Condition"
Defining a specific SEU value or an SEU value range requires to set
the operator to one of the following: equal, not equal, less than, less
than or equal, greater than, greater than or equal, in range, out of
range.
"Min"
Specifies an SEU value, or sets the start value of an SEU value
range.
"Max"
Sets the end value of an SEU value range if "Condition"
(TRIGger<m>:USB:SCONdition) is set to INRange or OORange.
Remote command:
TRIGger<m>:USB:WSEU on page 1805
TRIGger<m>:USB:SCONdition on page 1802
TRIGger<m>:USB:SMIN on page 1802
TRIGger<m>:USB:SMAX on page 1802
USB (option R&S
RTE-K60)