Rohde & Schwarz RTE - Page 1894

Remote control commands
R&S
®
RTE
1894User Manual 1326.1032.02 ─ 20
Parameters:
<ErrorIFS> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:ERRor:LENGth <SearchName>,<ErrorLength>
SEARch:TRIGger:CXPI:ERRor:LENGth? <SearchName>
Searches for a length error, if SEARch:TRIGger:CXPI:TYPE is set to ERRor.
Parameters:
<ErrorLength> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:ERRor:PARity <SearchName>,<ErrorParity>
SEARch:TRIGger:CXPI:ERRor:PARity? <SearchName>
Searches for a parity error, if SEARch:TRIGger:CXPI:TYPE is set to ERRor.
Parameters:
<ErrorParity> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:ERRor:UART <SearchName>,<ErrorUart>
SEARch:TRIGger:CXPI:ERRor:UART? <SearchName>
Searches for an UART error, if SEARch:TRIGger:CXPI:TYPE is set to ERRor.
Parameters:
<ErrorUart> ON | OFF
*RST: ON
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:FID:CONDition <SearchName>,<FrameIDOperator>
SEARch:TRIGger:CXPI:FID:CONDition? <SearchName>
Set the condition for the frame ID. You can define an exact value or a value range.
Parameters:
<FrameIDOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
Protocols