Rohde & Schwarz RTE - Page 1895

Remote control commands
R&S
®
RTE
1895User Manual 1326.1032.02 ─ 20
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIGger:CXPI:
FID:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range with SEARch:TRIGger:CXPI:FID:MIN and
SEARch:TRIGger:CXPI:FID:MAX.
*RST: EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:FID:MAX
<SearchName>,<FrameIDMax>
SEARch:TRIGger:CXPI:FID:MAX? <SearchName>
Sets the end value of a frame ID range if SEARch:TRIGger:CXPI:FID:CONDition
is set to INRange or OORange.
Parameters:
<FrameIDMax>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:FID:MIN <SearchName>,<FrameIDMin>
SEARch:TRIGger:CXPI:FID:MIN? <SearchName>
Specifies a frame ID pattern, or sets the start value of a pattern range.
Parameters:
<FrameIDMin>
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:CXPI:NM <SearchName>,<NM>
SEARch:TRIGger:CXPI:NM? <SearchName>
Sets the value of the network management (NM) field.
Parameters:
<NM>
Parameters for setting and query:
<SearchName>
Protocols