Triggers
R&S
®
RTE
269User Manual 1326.1032.02 ─ 20
Force Trigger
If the acquisition is running in normal mode and no valid trigger occurs, forcing the trig-
ger provokes an immediate single acquisition. Thus you can confirm that a signal is
available and use the waveform display to determine how to trigger on it.
If you need this function frequently, you can add the "Force Trigger" icon to the toolbar.
Remote command:
TRIGger<m>:FORCe on page 1207
[RUN CONT]/[RUN N× SINGLE]
Front panel keys to start and stop a continuous acquisition or a defined number of
acquisition cycles, respectively. The number of acquisitions is set with "Average count".
Remote command:
RUN on page 1107
SINGle on page 1107
STOP on page 1107
Show trigger lines permanently
Displays the trigger levels and the hysteresis in the diagrams until you disable this
option.
Remote command:
DISPlay:TRIGger:LINes on page 1167
Hysteresis transparency
Defines the transparency of the hysteresis area above or below the trigger level.
Only visible if Show trigger lines permanently is enabled.
Actions on trigger
The trigger can initiate several actions, each time a trigger occurs. To activate an
action, set it to "On trigger". The following actions are available:
"Beep"
Generates a beep sound.
"Print"
Saves a screenshot according to settings in "File" menu > "Print
Setup".
"Save Wfm"
Saves the waveform data to a file according to settings in [FILE] >
"Waveform / Results" > "Waveforms".
"Report"
Creates and saves a report using the settings defined in "File" menu
> "Report Setup".
"Start Executa-
ble"
Starts an external application. Tap "Config Executable" to set the
application path and parameters.
See: Chapter 4.5, "External application", on page 157.
Remote command:
TRIGger<m>:EVENt:BEEP on page 1208
TRIGger<m>:EVENt:PRINt on page 1209
TRIGger<m>:EVENt:WFMSave on page 1209
TRIGger<m>:EVENt:RUNexec on page 1209
Control / action
To Next Page
Loading...
