Measurements
R&S
®
RTE
342User Manual 1326.1032.02 ─ 20
Result display settings are described in Chapter 8.2.2.3, "Display settings for results",
on page 340.
Use gate
Considers the gating settings for the selected measurement and displays the gate.
Remote command:
MEASurement<m>:GATE[:STATe] on page 1302
Use gate coupling
If you enable the gate coupling, the gate settings of the selected measurement are
copied to all other measurements. Thus, all measurements use the same gate. If zoom
or cursor coupling is active in a measurement, the zoom size and cursor positions are
adjusted.
Remote command:
MEASurement<m>:GATE:GCOupling on page 1305
Mode
Defines whether the gate settings are configured using absolute or relative values.
"Absolute"
The gate is defined by absolute start and stop values.
"Relative"
The gate's start and stop values are defined by a percentage of the
value range.
Remote command:
CALCulate:MATH<m>:FFT:GATE:MODE on page 1323
MEASurement<m>:GATE:MODE on page 1303
SEARch:GATE:MODE on page 1379
Automatic measurements
To Next Page
Loading...
