Rohde & Schwarz RTE - Page 616

Protocol analysis
R&S
®
RTE
616User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:LIN:WUFRame on page 1547
SEARch:TRIGger:LIN:SERRor on page 1546
Identifier setup: Condition, Frame ID min, Frame ID max
The identifier setup consists of the condition and one or two frame ID patterns.
The identifier setup settings are the same as in the LIN trigger setup, see "Identifier
setup: Condition, Frame ID min, Frame ID max" on page 605.
Remote command:
SEARch:TRIGger:LIN:ICONdition on page 1547
SEARch:TRIGger:LIN:IMIN on page 1547
SEARch:TRIGger:LIN:IMAX on page 1547
Data setup: Condition, Data min, Data max, Data length, Transfer
The data setup consists of the transfer direction, the data length, the condition, and
one or two data patterns.
The data setup settings are the same as in the LIN trigger setup, see "Data setup: Data
length, Transfer, Condition, Data min, Data max" on page 606.
Remote command:
SEARch:TRIGger:LIN:DCONdition on page 1548
SEARch:TRIGger:LIN:DMIN on page 1549
SEARch:TRIGger:LIN:DMAX on page 1549
SEARch:TRIGger:LIN:DLECondition on page 1550
SEARch:TRIGger:LIN:DLENgth on page 1550
SEARch:TRIGger:LIN:BORDer on page 1549
Identifier OR setup: Monitor, Frame ID
The identifier OR setup consists of the monitor and frame ID.
The identifier OR setup settings are the same as in the LIN trigger setup, see "Identifier
OR setup: Monitor, Frame ID" on page 606
Remote command:
SEARch:TRIGger:LIN:IDOR<m>:ENABle on page 1548
SEARch:TRIGger:LIN:IDOR<m>[:VALue] on page 1548
Error Condition
Selects the error type to be searched for. You can select one or more error types as
search condition.
The error types are the same as in the LIN trigger setup, see "Error conditions"
on page 607.
Remote command:
SEARch:TRIGger:LIN:IPERror on page 1550
SEARch:TRIGger:LIN:SYERror on page 1551
SEARch:TRIGger:LIN:CHKSerror on page 1551
SEARch:TRIGger:LIN:ERRPattern on page 1551
SEARch:TRIGger:LIN:CRCDatalen on page 1552
SEARch:TRIGger:LIN:STANdard on page 1552
LIN (option R&S
RTE-K3)