Protocol analysis
R&S
®
RTE
736User Manual 1326.1032.02 ─ 20
Remote command:
BUS<m>:SENT:DATA:THReshold on page 1703
BUS<m>:SENT:TECHnology on page 1703
BUS<m>:SETReflevels on page 1421
BUS<m>:FAUToset on page 1421
Clock Period
Sets the transmitter-specific nominal clock period (clock tick).
The clock period and signal length determine the speed of transmission.
Remote command:
BUS<m>:SENT:CLKPeriod on page 1703
Clock tolerance
Specifies a tolerated deviation of the clock.
Remote command:
BUS<m>:SENT:CLKTolerance on page 1704
Data Nibbles
Sets the number of data units in a single transmission sequence.
The maximum number of data nibbles is 6.
Remote command:
BUS<m>:SENT:DNIBbles on page 1704
Serial protocol
Selects the protocol format in the transmitted signal.
"Short"
Short serial messages.
"Enhanced"
Enhanced serial messages.
"None"
No serial messages. Transmission sequences only.
Remote command:
BUS<m>:SENT:SFORmat on page 1704
CRC version
Selects the version the CRC check is based on.
"Legacy"
Based on the crc calculation version used earlier than 2010.
"v2010"
Based on the recent crc calculation version updated in 2010.
Remote command:
BUS<m>:SENT:CRCVersion on page 1704
CRC calculation
Selects the method for CRC calculation.
"SAE_J2716"
Calculates the CRC according to the SAE standard.
For this method the checksum is calculated over all nibbles except
the communication and status nibble.
SENT (option R&S RTE-K10)
To Next Page
Loading...
