TC1796
Peripheral Units (Vol. 2 of 2)
Controller Area Network (MultiCAN) Controller
User’s Manual 22-130 V2.0, 2007-07
MultiCAN, V2.0
INP [19:16] rw Interrupt Node Pointer
INP selects the interrupt output line INT_Om
(m = 0-15) that will be activated when a match is
detected between the cycle time and the time mark
value defined by TMV and if at least one of the four
interrupt conditions is met and enabled.
0000
B
Interrupt output line INT_O0 is selected.
0001
B
Interrupt output line INT_O1 is selected.
……
1110
B
Interrupt output line INT_O14 is selected.
1111
B
Interrupt output line INT_O15 is selected.
IENTRAF0 20 rw Interrupt Enable if TRAF = 0
This bit enables the generation of an interrupt when
a match is detected between the cycle time and the
time mark value defined by TMV and bit TRAF = 0.
0
B
An interrupt will not be generated.
1
B
An interrupt will be generated.
IENTRAF1 21 rw Interrupt Enable if TRAF = 1
This bit enables the generation of an interrupt when
a match is detected between the cycle time and the
time mark value defined by TMV and bit TRAF = 1.
0
B
An interrupt will not be generated.
1
B
An interrupt will be generated.
IENRECF0 22 rw Interrupt Enable if RECF = 0
This bit enables the generation of an interrupt when
a match is detected between the cycle time and the
time mark value defined by TMV and bit RECF = 0.
0
B
An interrupt will not be generated.
1
B
An interrupt will be generated.
IENRECF1 23 rw Interrupt Enable if RECF = 1
This bit enables the generation of an interrupt when
a match is detected between the cycle time and the
time mark value defined by TMV and bit RECF = 1.
0
B
An interrupt will not be generated.
1
B
An interrupt will be generated.
EC [31:28] rw Entry Code
The entry code EC = 0010
B
defines this scheduler
memory entry as an interrupt control entry.
Field Bits Type Description
To Next Page
Loading...