Rohde & Schwarz RTE - Page 1110

Remote control commands
R&S
®
RTE
1110User Manual 1326.1032.02 ─ 20
See also: TIMebase:HORizontal:POSition on page 1109
Suffix:
<m>
.
1..3
The numeric suffix is irrelevant.
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
AUToscale
Performs an autoset process: analyzes the enabled channel signals, and obtains
appropriate horizontal, vertical, and trigger settings to display stable waveforms.
Rohde & Schwarz does not recommend using the autoset in remote control. To adjust
the oscilloscope remotely, especially for automated testing applications, use the
remote commands that adjust the horizontal, vertical and trigger settings.”
Usage:
Event
Asynchronous command
ACQuire:POINts:AUTO <ReclgthManual>
Selection to keep constant either the resolution or the record length when you adjust
the time scale (TIMebase:SCALe) or acquisition time (TIMebase:RANGe).
Parameters:
<ReclgthManual> RESolution | RECLength
RESolution
Resolution is kept constant. Set the required resolution value
with ACQuire:RESolution.
RECLength
The record length is kept constant. Set the required record
length value with ACQuire:POINts[:VALue].
*RST: RESolution
Usage: Asynchronous command
ACQuire:POINts:AADJust <AutoAdjust>
Prevents undersampling and ensures a sufficient resolution to acquire the correct
waveform if the time scale is changed. The setting takes effect if the changed parame-
ter - resolution or record length - reaches a limit. The instrument automatically keeps
this parameter constant at its limit, and changes the other parameter regardless of the
ACQuire:POINts:AUTO setting.
Acquisition and setup