Remote control commands
R&S
®
RTE
1336User Manual 1326.1032.02 ─ 20
MTESt:SEGMent:POINt:COUNt?...................................................................................1338
MTESt:SEGMent:POINt:X.............................................................................................1339
MTESt:SEGMent:POINt:Y.............................................................................................1339
MTESt:SEGMent:RESCale:RECalculate........................................................................ 1339
MTESt:SEGMent:RESCale:XFACtor..............................................................................1340
MTESt:SEGMent:RESCale:YFACtor..............................................................................1340
MTESt:SEGMent:RESCale:XOFFset............................................................................. 1340
MTESt:SEGMent:RESCale:YOFFset............................................................................. 1341
MTESt:SEGMent:STATe <MaskTestName>, <MaskSegmIdx>,<State>
MTESt:SEGMent:STATe? <MaskTestName>, <MaskSegmIdx>
Enables and disables the mask segment. Disabled segments are not considered by
running tests.
Parameters:
<State> ON | OFF
*RST: ON
Parameters for setting and query:
<MaskTestName> String with the name of the mask test
<MaskSegmIdx> Number of the segment. Counting starts from 0.
Usage: Asynchronous command
MTESt:SEGMent:ADD <MaskTestName>
Creates a new segment in the mask definition.
Setting parameters:
<MaskTestName> String with the name of the mask test
Example: See Chapter 18.3.3.1, "Creating a user mask", on page 1060
Usage: Setting only
Asynchronous command
MTESt:SEGMent:COUNt? <MaskTestName>
Returns the number of segments in the mask definition
Query parameters:
<MaskTestName> String with the name of the mask test
Return values:
<Count> Number of segments
Usage: Query only
MTESt:SEGMent:INSert <MaskTestName>, <MaskSegmIdx>
Inserts a new segment before the specified index in the mask definition.
Mask testing
To Next Page
Loading...
