Rohde & Schwarz RTE - Page 1616

Remote control commands
R&S
®
RTE
1616User Manual 1326.1032.02 ─ 20
Parameters:
<DataIndexMax> Range: 1 to 32
Increment: 1
*RST: 32
TRIGger<m>:MILStd:DATA:IMIN <DataIndexMin>
Specifies an index or sets the the start value of a data word series index range.
Parameters:
<DataIndexMin> Range: 1 to 32
Increment: 1
*RST: 1
TRIGger<m>:MILStd:ERRor:MANChester
<ManCodingError>
Triggers on an error of the manchester coding if TRIGger<m>:MILStd:TYPE is set to
ERRor.
Parameters:
<ManCodingError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:ERRor:PARity <ParityError>
Triggers on even parity if TRIGger<m>:MILStd:TYPE is set to ERRor.
Parameters:
<ParityError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:ERRor:SYNC <SyncError>
Triggers on an error of the synchronization if TRIGger<m>:MILStd:TYPE is set to
ERRor.
Parameters:
<SyncError> ON | OFF
*RST: ON
TRIGger<m>:MILStd:MAXResponse:BITS <MaxResponseTime>
Sets the value for the maximum response time to be triggered on if TRIGger<m>:
MILStd:TYPE is set to ERRor
Enable the error trigger on maximum response time with TRIGger<m>:MILStd:
MAXResponse:SELect.
Protocols