Rohde & Schwarz RTE - Page 1643

Remote control commands
R&S
®
RTE
1643User Manual 1326.1032.02 ─ 20
SEARch:TRIGger:ARINc:ERRor:CODing....................................................................... 1644
SEARch:TRIGger:ARINc:ERRor:PARity......................................................................... 1645
SEARch:TRIGger:ARINc:ERRor:TIMing.........................................................................1645
SEARch:TRIGger:ARINc:TYPE <SearchName>,<Type>
SEARch:TRIGger:ARINc:TYPE? <SearchName>
Sets the search type.
Parameters:
<Type> STARt | STOP | LABel | ERRor
*RST: STARt
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:ARINc:LABel:CONDition
<SearchName>,<LabelOperator>
SEARch:TRIGger:ARINc:LABel:CONDition? <SearchName>
SEARch:TRIGger:ARINc:DATA:CONDition <SearchName>,<DataOperator>
SEARch:TRIGger:ARINc:DATA:CONDition? <SearchName>
Set the condition for the label or data, respectively. You can define an exact value or a
value range
Parameters:
<DataOperator> EQUal | NEQual | LTHan | LETHan | GTHan | GETHan |
INRange | OORange
EQUal | NEQual | LTHan | LETHan | GTHan | GETHan
Equal, Not equal, Less than, Less or equal than, Greater Than,
Greater or equal than. These conditions require one data pattern
to be set with the corresponding SEARch:TRIG
ger:ARINc:...:MIN command.
INRange | OORange
In range/Out of range: set the minimum and maximum value of
the range. withTRIGger<m>:ARINc:LABel:MIN and
TRIGger<m>:ARINc:LABel:MAX.
*RST:
EQUal
Parameters for setting and query:
<SearchName>
SEARch:TRIGger:ARINc:LABel:MIN <SearchName>,<LabelMin>
SEARch:TRIGger:ARINc:LABel:MIN? <SearchName>
SEARch:TRIGger:ARINc:DATA:MIN <SearchName>,<DataMin>
SEARch:TRIGger:ARINc:DATA:MIN? <SearchName>
Specifies a label or data bit pattern, or sets the the start value of a pattern range.
Protocols