Protocol analysis
R&S
®
RTE
675User Manual 1326.1032.02 ─ 20
The data pattern setup settings are the same as in the MIL trigger setup, see "Data
Pattern" on page 665.
Remote command:
SEARch:TRIGger:MILStd:DATA:DCONdition on page 1626
SEARch:TRIGger:MILStd:DATA:DMIN on page 1626
SEARch:TRIGger:MILStd:DATA:DMAX on page 1627
Data index setup: Condition, Index min, Index max
The data index setup consists of the condition and one or two index patterns.
The data index setup settings are the same as in the MIL trigger setup, see "Data
Index" on page 666.
Remote command:
SEARch:TRIGger:MILStd:DATA:ICONdition on page 1627
SEARch:TRIGger:MILStd:DATA:IMIN on page 1627
SEARch:TRIGger:MILStd:DATA:IMAX on page 1627
11-Bit information setup: Condition, Info min, Info max
The 11-bit information setup consists of the condition and one or two 11-bit information
patterns.
The 11-bit information setup settings are the same as in the MIL trigger setup, see "11-
Bit Information" on page 666.
Remote command:
SEARch:TRIGger:MILStd:CDST:ICONdition on page 1625
SEARch:TRIGger:MILStd:CDST:IMIN on page 1626
SEARch:TRIGger:MILStd:CDST:IMAX on page 1626
Subaddress / Mode setup: Condition, Subaddress min, Subaddress max
The subaddress/mode setup consists of the condition and one or two subaddress/
mode patterns.
The subaddress/mode setup settings are the same as in the MIL trigger setup, see
"Subaddress/ Mode" on page 667.
Remote command:
SEARch:TRIGger:MILStd:CMD:SCONdition on page 1626
SEARch:TRIGger:MILStd:CMD:SMIN on page 1626
SEARch:TRIGger:MILStd:CMD:SMAX on page 1627
Data word count / Mode code setup: Condition, Word count min, Word count
max
The data word count/mode code setup consists of the condition and one or two pat-
terns.
The subaddress/mode setup settings are the same as in the MIL trigger setup, see
"Data Word Count/Mode Code" on page 667.
Remote command:
SEARch:TRIGger:MILStd:CMD:CCONdition on page 1625
SEARch:TRIGger:MILStd:CMD:CMIN on page 1626
SEARch:TRIGger:MILStd:CMD:CMAX on page 1626
MIL-1553 (option R&S
RTE-K6)