www.ti.com
DCAN Control Registers
1471
SPNU563A–March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
Controller Area Network (DCAN) Module
27.17.16 New Data X Register (DCAN NWDAT X)
With the New Data X Register, the CPU can detect if one or more bits in the different New Data Registers
are set. Each register bit represents a group of eight message objects. If at least on of the NewDat bits of
these message objects are set, the corresponding bit in the New Data X Register will be set.
Figure 27-38. New Data X Register (DCAN NWDAT X) [offset = 98h]
31 16
Reserved
R-0
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
NewDatReg8 NewDatReg7 NewDatReg6 NewDatReg5 NewDatReg4 NewDatReg3 NewDatReg2 NewDatReg1
R-0 R-0 R-0 R-0 R-0 R-0 R-0 R-0
LEGEND: R = Read only; -n = value after reset
Equation 1
Bit 0 of the New Data X Register represents byte 0 of the New Data 1 Register. If one or more bits in this
byte are set, bit 0 of the New Data X Register will be set.
To Next Page
Loading...
