Interrupt
Enable
Interrupt
Priority
High
Low
OFFSET B
OFFSET A
OVRF Period
Sign. Not Found
Tooth Interrupt
ACNT OVRF
Criteria Found
Angle Inc. OVRF
Priority
Priority
Bad active edge tooth
Flag
Gap flag
Angle Functions
www.ti.com
1008
SPNU563A–March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
High-End Timer (N2HET) Module
For more information on these interrupts, see Table 23-14. Each interrupt source is associated with a low
or high priority. When one or more interrupts with the same priority occur, a fixed priority determines the
offset vector if the corresponding enable bits are set.
The HWAG generates two interrupt request signals for the central interrupt module (CIM). For information
on servicing interrupts, see Figure 23-49. For a list offset values, see Table 23-13.
Table 23-13. HWAG Interrupt Sources and Offset Values
Source Number Offset Value
0 1
1 2
: :
7 8
Figure 23-49. HWAG Interrupt Block Diagram
To Next Page
Loading...
Need help?
General
