MDIO Registers
www.ti.com
1870
SPNU563A–March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
EMAC/MDIO Module
32.4.5 MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
The MDIO link status change interrupt (unmasked) register (LINKINTRAW) is shown in Figure 32-32 and
described in Table 32-29.
Figure 32-32. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW) (offset =
10h)
31 16
Reserved
R-0
15 2 1 0
Reserved USERPHY1 USERPHY0
R-0 R/W1C-0 R/W1C-0
LEGEND: R/W = Read/Write; R = Read only; W1C = Write 1 to clear (writing a 0 has no effect); -n = value after reset
Table 32-29. MDIO Link Status Change Interrupt (Unmasked) Register (LINKINTRAW)
Field Descriptions
Bit Field Value Description
31-2 Reserved 0 Reserved
1 USERPHY1 MDIO Link change event, raw value. When asserted, the bit indicates that there was an MDIO link
change event (that is, change in the LINK register) corresponding to the PHY address in
USERPHYSEL1. Writing a 1 will clear the event, writing a 0 has no effect.
0 No MDIO link change event.
1 An MDIO link change event (change in the LINK register) corresponding to the PHY address in
MDIO user PHY select register USERPHYSEL1.
0 USERPHY0 MDIO Link change event, raw value. When asserted, the bit indicates that there was an MDIO link
change event (that is, change in the LINK register) corresponding to the PHY address in
USERPHYSEL0. Writing a 1 will clear the event, writing a 0 has no effect.
0 No MDIO link change event.
1 An MDIO link change event (change in the LINK register) corresponding to the PHY address in
MDIO user PHY select register USERPHYSEL0.
To Next Page
Loading...
