Mask testing
R&S
®
RTE
428User Manual 1326.1032.02 ─ 20
●
Append a new segment at the end of the list.
●
Remove the selected mask segment from the list.
●
Select the region that builds the mask.
– Inner region: the segment points form a closed geometrical shape, which is the
mask segment.
– Upper region: the segment points are connected to a line, the display area
above this line is the mask segment.
– Lower region: the segment points are connected to a line, the display area
below this line is the mask segment.
●
Enable and disable the mask segments individually. Disabled segments are not
considered by running tests.
Remote command:
MTESt:SEGMent:STATe on page 1336
MTESt:SEGMent:ADD on page 1336
MTESt:SEGMent:REMove on page 1337
MTESt:SEGMent:INSert on page 1336
MTESt:SEGMent:REGion on page 1337
MTESt:SEGMent:COUNt? on page 1336
Definition of segment
The number of the selected segment is shown above the table. In the definition table,
the individual points of the selected mask segment are listed with exact horizontal and
vertical numerical coordinates. Here you can:
●
Insert a new point before the selected point.
●
Append a new point at the end of the list.
●
Remove the selected point from the list.
●
Change the x- and y-values of each point. To scale or move the complete segment,
use offset and factor values, see Rescale.
Remote command:
MTESt:SEGMent:POINt:ADD on page 1338
MTESt:SEGMent:POINt:REMove on page 1338
MTESt:SEGMent:POINt:INSert on page 1338
MTESt:SEGMent:POINt:X on page 1339
MTESt:SEGMent:POINt:Y on page 1339
MTESt:SEGMent:POINt:COUNt? on page 1338
Rescale
You can rescale and move mask segments by numerical input of factors and offsets.
The values change the selected mask segment and take effect on "Recalculate".
Offset X ← Rescale
Moves the mask segment horizontally. The specified offset is added to the x-values of
all points of the selected mask segment.
To take effect, tap "Recalculate".
Remote command:
MTESt:SEGMent:RESCale:XOFFset on page 1340
Mask test settings
To Next Page
Loading...
