Control Registers
www.ti.com
1578
SPNU563A–March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
Multi-Buffered Serial Peripheral Interface Module (MibSPI) with Parallel Pin
Option (MibSPIP)
28.3.29 Transfer Group Interrupt Level Set Register (TGITLVST)
The register TGITLVST sets the level of interrupts for transfer completed interrupt and for transfer
suspended interrupt to level 1.
The register map shown in Figure 28-64 andTable 28-38 represents a super-set device with the maximum
number of TGs (16) assumed. The actual number of bits available varies per device.
Figure 28-64. Transfer Group Interrupt Level Set Register (TGITLVST) [offset = 7Ch]
31 16
SETINTLVLRDY[15:0]
R/W-0
15 0
SETINTLVLSUS[15:0]
R/W-0
LEGEND: R/W = Read/Write; -n = value after reset
Table 28-38. Transfer Group Interrupt Level Set Register (TGITLVST) Field Descriptions
Bit Field Value Description
31-16 SETINTLVLRDY[n] Transfer-group completed interrupt level set. Bit 16 corresponds to TG0, bit 17 corresponds to
TG1, and so on.
0 Read: The TGx-completed interrupt is set to INT0.
Write: A write of 0 to this bit has no effect.
1 Read: The TGx-completed interrupt is set to INT1.
Write: Set the TGx-completed interrupt to INT1.
15-0 SETINTLVLSUS[n] Transfer-group suspended interrupt level set. Bit 0 corresponds to TG0, bit 1 corresponds to
TG1, and so on.
0 Read: The TGx-suspended interrupt is set to INT0.
Write: A write of 0 to this bit has no effect.
1 Read: The TGx-suspended interrupt is set to INT1.
Write: Set the TG-x suspended interrupt to INT1.
To Next Page
Loading...
Need help?
General
