Texas Instruments TMS570LC4357 - Page 1874

MDIO Registers www.ti.com
1874
SPNU563A–March 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
EMAC/MDIO Module
32.4.9 MDIO User Command Complete Interrupt Mask Set Register (USERINTMASKSET)
The MDIO user command complete interrupt mask set register (USERINTMASKSET) is shown in
Figure 32-36 and described in Table 32-33.
Figure 32-36. MDIO User Command Complete Interrupt Mask Set Register (USERINTMASKSET)
(offset = 28h)
31 16
Reserved
R-0
15 2 1 0
Reserved USERACCESS1 USERACCESS0
R-0 R/W1S-0 R/W1S-0
LEGEND: R/W = Read/Write; R = Read only; W1S = Write 1 to set (writing a 0 has no effect); -n = value after reset
Table 32-33. MDIO User Command Complete Interrupt Mask Set Register (USERINTMASKSET)
Field Descriptions
Bit Field Value Description
31-2 Reserved 0 Reserved
1 USERACCESS1 MDIO user interrupt mask set for USERINTMASKED[1]. Setting a bit to 1 will enable MDIO user
command complete interrupts for the USERACCESS1 register. MDIO user interrupt for
USERACCESS1 is disabled if the corresponding bit is 0. Writing a 0 to this bit has no effect.
0 MDIO user command complete interrupts for the MDIO user access register USERACCESS0 is
disabled.
1 MDIO user command complete interrupts for the MDIO user access register USERACCESS0 is
enabled.
0 USERACCESS0 MDIO user interrupt mask set for USERINTMASKED[0]. Setting a bit to 1 will enable MDIO user
command complete interrupts for the USERACCESS0 register. MDIO user interrupt for
USERACCESS0 is disabled if the corresponding bit is 0. Writing a 0 to this bit has no effect.
0 MDIO user command complete interrupts for the MDIO user access register USERACCESS0 is
disabled.
1 MDIO user command complete interrupts for the MDIO user access register USERACCESS0 is
enabled.