Enterasys C3G124-24 - Show Snmp Targetparams Output Details

show snmp targetparams
Enterasys C3 Configuration Guide 12-23
Defaults
If targetParams is not specified, entries associated with all target parameters will be displayed.
If not specified, entries of all storage types will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display SNMP target parameters information:
C3(su)->show snmp targetparams
--- SNMP TargetParams information ---
Target Parameter Name = v1ExampleParams
Security Name = public
Message Proc. Model = SNMPv1
Security Level = noAuthNoPriv
Storage type = nonVolatile
Row status = active
Target Parameter Name = v2cExampleParams
Security Name = public
Message Proc. Model = SNMPv2c
Security Level = noAuthNoPriv
Storage type = nonVolatile
Row status = active
Target Parameter Name = v3ExampleParams
Security Name = CharlieDChief
Message Proc. Model = USM
Security Level = authNoPriv
Storage type = nonVolatile
Row status = active
Table 12-7 provides an explanation of the command output.
Table 12-7 show snmp targetparams Output Details
Output Field What It Displays...
Target Parameter Name Unique identifier for the parameter in the SNMP target parameters table.
Maximum length is 32 bytes.
Security Name Security string definition.
Message Proc. Model SNMP version.
Security Level Type of security level (auth: security level is set to use authentication
protocol, noauth: security level is not set to use authentication protocol,
or privacy).
Storage type Whether entry is stored in volatile, nonvolatile or read-only memory.
Row status Status of this entry: active, notInService, or notReady.