clear dhcpsnooping statistics
Enterasys C3 Configuration Guide 23-13
Parameters
Defaults
If no parameters are entered, all bindings (static and dynamic) are removed.
Mode
Switch command, read-write.
Example
This example clears the static binding entry that includes port ge.1.2.
C3(su)->clear dhcpsnooping binding port ge.1.2
clear dhcpsnooping statistics
Use this command to clear the DHCP snooping statistics counters.
Syntax
clear dhcpsnooping statistics
Parameters
None.
Defaults
None.
Mode
Switch command, read-write.
Example
This example clears the DHCP snooping statistics counters for all enabled untrusted ports.
C3
(su)->clear dhcpsnooping statistics
clear dhcpsnooping limit
Use this command to reset the rate limit values to the defaults of 15 packets per second with a
burst interval of 1 second.
Syntax
clear dhcpsnooping limit port-string
Parameters
port port-string (Optional) Specifies the entry or entries to remove by port identifier.
mac mac-addr (Optional) Specifies the entry to remove by MAC address.
port-string Specifies the port or ports to which this command applies.
To Next Page
Loading...
