clear ip ospf process
27-24 IPv4 Advanced Routing Protocol Configuration
clear ip ospf process
Use this command to reset the OSPF process. This will require adjacencies to be reestablished and
routes to be reconverged.
Syntax
clear ip ospf process process-id
Parameters
Defaults
None.
Mode
Privileged EXEC: C3(su)->router#
Example
This example shows how to reset OSPF process 1:
C3(su)->router#clear ip ospf process 1
Timer intervals
configured
Timer intervals configured for the virtual link, including Hello, Wait, and Retransmit
intervals.
Adjacency State State of adjacency between this router and the virtual link neighbor of this router.
Table 27-5 show ip ospf virtual links Output Details (Continued)
Output Field What It Displays...
process-id Specifies the process ID, an internally used identification number for each
instance of the OSPF routing process run on a router. Valid values are 1 to
65535.
To Next Page
Loading...
Need help?
General