clear snmp targetparams
Enterasys C3 Configuration Guide 12-25
clear snmp targetparams
Use this command to clear the SNMP target parameter configuration.
Syntax
clear snmp targetparams targetParams
Parameters
Defaults
None.
Mode
Switch mode, read-write, when security profile = normal.
Switch mode, super-user, when security profile = C2.
Example
This example shows how to clear SNMP target parameters named “v1ExampleParams”:
C3(su)->clear snmp targetparams v1ExampleParams
Configuring SNMP Target Addresses
Purpose
To review and configure SNMP target addresses which will receive SNMP notification messages.
An address configuration can be linked to optional SNMP transmit, or target, parameters (such as
timeout, retry count, and UDP port) set with the set snmp targetparams command (page 12-24).
Commands
show snmp targetaddr
Use this command to display SNMP target address information.
Syntax
show snmp targetaddr [targetAddr] [volatile | nonvolatile | read-only]
targetParams Specifies the name of the parameter in the SNMP target parameters table
to be cleared.
For information about... Refer to page...
show snmp targetaddr 12-25
set snmp targetaddr 12-26
clear snmp targetaddr 12-28
To Next Page
Loading...
