show ipv6 ospf abr
Enterasys C3 Configuration Guide 31-33
show ipv6 ospf abr
This command displays OSPFv3 routes to reach area border routers.
Syntax
show ipv6 ospf abr
Parameters
None.
Defaults
None.
Mode
Router privileged execution: C3(su)->router#
Example
This example shows how to display OSPFv3 area border router information.
C3(su)->router# show ipv6 ospf abr
Type Router Id Cost Area ID Next Hop Next Hop
Intf
----- -------------- ---- ------------ -------------------------------- --------
INTRA 82.15.0.1 10 0.0.0.10 FE80::200:2DFF:FEE6:FB6B Vlan 48
Table 31-3 provides an explanation of the command output.
Area LSA Checksum Number representing the Area LSA Checksum for the specified
Area ID excluding the external (LS type 5) link-state
advertisements.
Stub Mode Whether the specified area is a stub area or not. The possible
values are enabled and disabled. This is a configured value.
Import Summary LSAs Whether to import summary LSAs (enabled or disabled).
OSPF Stub Metric Value Metric value of the stub area. This field displays only if the area is
a configured as a stub area.
Table 31-2 show ipv6 ospf area Output Details (Continued)
Output Field What It Displays...
Table 31-3 show ipv6 ospf abr Output Details
Output Field What It Displays...
Type The type of the route to the destination, which is one of the
following values:
INTRA — Intra-area route
INTER — Inter-area route
Router ID Router ID of the destination.
Cost Cost of using this route.
Area ID The area ID of the area from which this route is learned.
To Next Page
Loading...
Need help?
General