History Group Commands
21-6 RMON Configuration
History Group Commands
Purpose
To display, configure, and clear RMON history properties and statistics.
Commands
show rmon history
Use this command to display RMON history properties and statistics. The RMON history group
records periodic statistical samples from a network.
Syntax
show rmon history [port-string]
Parameters
Defaults
If port-string is not specified, information about all RMON history entries will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display RMON history entries for Gigabit Ethernet port 1 in switch 1.
A control entry displays first, followed by actual entries corresponding to the control entry. In this
case, the default settings for entry owner, sampling interval, and maximum number of entries.
(buckets) have not been changed from their default values. For a description of the types of
statistics shown, refer to Table 21-2.
:
C3(su)->show rmon history ge.1.1
Port: ge.1.1
-------------------------------------
Index 1
Owner = monitor
Status = valid
Data Source = ifIndex.1
Interval = 30
Buckets Requested = 50
Buckets Granted = 10
For information about... Refer to page...
show rmon history 21-6
set rmon history 21-7
clear rmon history 21-7
port-string (Optional) Displays RMON history entries for specific port(s).
To Next Page
Loading...
Need help?
General