Enterasys C3G124-24 - Implementation Defaults; Commands; Show Ipsec

Configuring IPsec Commands
33-2
Implementation Defaults
• IPsec is disabled by default for RADIUS transactions.
• The default authentication protocol is HMAC-SHA1.
• The default encryption method is AES128.
• The default IKE Diffie-Hellman group is group-1 (768 bits).
• The default IKE lifetime main mode interval is 60 minutes.
• The default IKE lifetime quick mode interval is 5 minutes.
• The default IKE lifetime bandwidth is 100000 bytes.
• The default IKE protocol is main.
• The default authentication method is secret.
Commands
show ipsec
Use this command to display the current IPsec values.
Syntax
show ipsec
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows the output of this command.
C3(su)->show ipsec
For information about... Refer to page...
show ipsec 33-2
set ipsec authentication 33-3
set ipsec encryption 33-3
set ipsec ike dh-group 33-4
set ipsec ike lifetime 33-5
set ipsec ike phase1 33-5
set ipsec ike version 33-6