show newaddrtrap
11-32 Port Configuration
show newaddrtrap
Use this command to display the global and port-specific status of the new MAC addresses trap
function.
Syntax
show newaddrtrap [port-string]
Parameters
Defaults
If port-string is not specified, the status of the new MAC addresses trap function will be displayed
for all ports.
Mode
Switch command, read-only.
Usage
By default, this function is disabled globally and per port.
Example
This example displays the New Address Trap state for ports 1 through 5 in unit/slot 1.
C3(ro)->show newaddrtrap ge.1.1-5
New Address Traps Globally disabled
Port Enable State
--------- ------------
ge.1.1 disabled
ge.1.2 disabled
ge.1.3 disabled
ge.1.4 disabled
ge.1.5 disabled
set newaddrtrap
Use this command to enable or disable trap messaging, globally or on one or more ports, when
new source MAC addresses are detected.
Syntax
set newaddrtrap [port-string] {enable | disable}
port-string (Optional) Displays the status of the new MAC addresses trap function
on specific ports.
To Next Page
Loading...
Need help?
General