set sflow receiver owner
Enterasys C3 Configuration Guide 37-7
set sflow receiver owner
Use this command to configure the owner identity string and timeout value for an sFlow Collector
in the switch’s sFlow Receivers Table.
Syntax
set sflow receiver index owner owner-string timeout timeout
Parameters
Defaults
None.
Mode
Switch command, read-write.
Usage
In order for an sFlow Collector to be assigned to receive sample datagrams from the sFlow Agent
on the switch, an entry for that Collector must be configured in the switch’s sFlow Receivers Table.
An entry must contain an owner identity string, a non-zero timeout value, and the IP address of
the Collector. Configure the IP address with the set sflow receiver ip command.
An entry without an owner identity string is considered unclaimed and cannot be assigned as a
receiver to sampler or poller instances.
Once the timer set by this command expires, the receiver/Collector and all the samplers and
pollers associated with this Collector expire and are removed from the switch’s configuration. In
order to start sending sample data to the Collector again, the Collector must be reconfigured with
a new timeout value and samplers and pollers must be configured again. Therefore, you should
consider setting the timeout value to the largest value that is reasonable for your environment.
Example
This example configures an entry for index 1 in the sFlow Receivers Table.
C3
(su)->set sflow receiver 1 owner ets1 timeout 180000
set sflow receiver ip
Use this command to configure the IP address of an sFlow Collector in the switch’s sFlow
Receivers Table.
Syntax
set sflow receiver index ip ipaddr
index Index number in the sFlow Receivers Table for the receiver/Collector
being configured. The index can range from 1 to 8.
owner owner-string The identity string of the receiver/Collector being configured.
The string can be up to 127 characters in length.
timeout timeout The time, in seconds, remaining before the receiver/Collector being
configured and all associated samplers and pollers expire.
The value can range from 0 to 4294967295 seconds.
To Next Page
Loading...
Need help?
General