Enterasys C3G124-24 - Configuring SNMP MIB Views; Commands; Purpose; Show Snmp View

Configuring SNMP MIB Views
Enterasys C3 Configuration Guide 12-19
Configuring SNMP MIB Views
Purpose
To review and configure SNMP MIB views. SNMP views map SNMP objects to access rights.
Commands
show snmp view
Use this command to display the MIB configuration for SNMPv3 view-based access (VACM).
Syntax
show snmp view [viewname] [subtree oid-or-mibobject] [volatile | nonvolatile |
read-only]
Parameters
Defaults
If no parameters are specified, all SNMP MIB view configuration information will be displayed.
Mode
Switch command, read-only.
Example
This example shows how to display SNMP MIB view configuration information:
C3(su)->show snmp view
--- SNMP MIB View information ---
View Name = All
Subtree OID = 1
Subtree mask =
View Type = included
Storage type = nonVolatile
Row status = active
For information about... Refer to page...
show snmp view 12-19
show snmp context 12-20
set snmp view 12-21
clear snmp view 12-21
viewname (Optional) Displays information for a specific MIB view.
subtree oid-or-mibobject (Optional) Displays information for a specific MIB subtree when
viewname is specified.
volatile | nonvolatile |
read-only
(Optional) Displays entries for a specific storage type.