Enterasys C3G124-24 - Clear Vlan Association

clear vlan association
Enterasys C3 Configuration Guide 14-27
Defaults
None.
Mode
Switch command, read-write.
Usage
Only protocol-based VLAN associations are supported on A4 switches. Use the set vlan
dynamicegress command to ensure that the receiving port is added to the egress list for the
VLAN.
Examples
This example classifies a MAC address to VLAN 2.
C3(su)->set vlan association mac 00-00-0c-40-0f-bc 2
C3(su)->set vlan dynamicegress 2 enable
This example classifies two protocols to VLAN 3.
C3(su)->set vlan association protocol arp,ip 3
C3(su)->set vlan dynamicegress 3 enable
This example classifies subnet 192.168.10.0 to VLAN 4.
C3(su)->set vlan association subnet 192.168.10.0 255.255.255.0 4
C3(su)->set vlan dynamicegress 4 enable
clear vlan association
Use this command to clear, or delete, VLAN associations.
Syntax
clear vlan association [mac [mac-addr]] | [subnet [ip-addr ip-mask]] | [protocol
[protocol-list]]
Parameters
protocol protocol-list Specifies the protocol or list of protocols for the VLAN association.
Specify the protocols by keyword or hexadecimal or decimal values,
separated by commas (,).
Keywords can be: arp, ip, or ipx.
Hexidecimal or decimal values can be in the range of 0x0600(1536) to
0xFFFF(65535).
vlan-id Specifies the VLAN.
mac [mac-addr] (Optional) Specifies the MAC address for the VLAN association to clear.
The MAC address can be formatted as xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-
xx-xx.
If a specific MAC address is not entered, all MAC VLAN associations
are cleared.