General Configuration Commands
Enterasys C3 Configuration Guide 29-3
General Configuration Commands
ipv6 forwarding
This command enables or disables IPv6 forwarding on the router.
Syntax
ipv6 forwarding
no ipv6 forwarding
Parameters
None.
Defaults
IPv6 forwarding is enabled.
Mode
Router global configuration: C3(su)->router(Config)#
Usage
The no form of this command disables IPv6 forwarding on the router.
Example
This example disables IPv6 forwarding.
C3(su)->router(Config)# no ipv6 forwarding
ipv6 hop-limit
This command sets the maximum number of IPv6 hops used in IPv6 packets and router
advertisements generated by this device.
Syntax
ipv6 hop-limit hops
no ipv6 hop-limit
For information about... Refer to page...
ipv6 forwarding 29-3
ipv6 hop-limit 29-3
ipv6 route 29-4
ipv6 route distance 29-5
ipv6 unicast-routing 29-6
ping ipv6 29-6
ping ipv6 interface 29-7
traceroute ipv6 29-8
To Next Page
Loading...
