Enterasys C3G124-24 - Reviewing Port Status

Reviewing Port Status
11-2 Port Configuration
Where port number depends on the device. The highest valid port number is dependent on the
number of ports in the device and the port type.
Port Slot/Unit Parameters Used in the CLI
The “unit” parameter is often used interchangeably with “module” in the standalone switch CLI
to indicate a module slot location.
Examples
unit This example shows the port-string syntax for specifying the 1-Gigabit Ethernet port 14 in
unit 3
.
ge.3.14
This example shows the port-string syntax for specifying all 1-Gigabit Ethernet ports in unit 3 in
the system.
ge.3.*
This example shows the port-string syntax for specifying all ports (of any interface type) in the
system.
*.*.*
Reviewing Port Status
Purpose
To display operating status, duplex mode, speed, port type, and statistical information about
traffic received and transmitted through one or all switch ports on the device.
Commands
show port
Use this command to display whether or not one or more ports are enabled for switching.
Syntax
show port [port-string]
Note: You can use a wildcard (*) to indicate all of an item. For example, fe.3.* would represent all
100Mbps Ethernet (fe) ports in unit 3, and ge.3 * would represent all 1-Gigabit Ethernet (ge) ports
in unit 3.
For information about... Refer to page...
show port 11-2
show port status 11-3
show port counters 11-4
clear port counters 11-5
show port cablestatus 11-6