Enterasys C3G124-24 - Show Lldp Port Local-Info

show lldp port local-info
10-18 Discovery Protocol Configuration
Defaults
If port-string is not specified, port location configuration information will be displayed for all
ports.
Mode
Switch command, read-only.
Example
This example shows how to display port location information for three ports.
C3(ro)->show lldp port location-info ge.1.1-3
Ports Type Location
-------- ------------- -------------------------
ge.1.1 ELIN 1234567890
ge.1.2 ELIN 1234567890
ge.1.3 ELIN 1234567890
show lldp port local-info
Use this command to display the local system information stored for one or more ports. You can
use this information to detect misconfigurations or incompatibilities between the local port and
the attached endpoint device (remote port).
Syntax
show lldp port local-info [port-string]
Parameters
Defaults
If port-string is not specified, local system information will be displayed for all ports.
Mode
Switch command, read-only.
Example
This example shows how to display the local system information stored for port ge.4.1. Table 10-4
describes the output fields of this command.
C3(rw)->show lldp port local-info ge.4.1
Local Port :
ge.4.1 Local Port Id: ge.4.1
--------------------
Port Desc : ... 1000BASE-TX RJ45 Gigabit Ethernet Frontpanel Port
Mgmt Addr : 10.21.64.100
Chassis ID : 00-E0-63-93-74-A5
Sys Name : LLDP PoE test Chassis
Sys Desc : Enterasys Networks, Inc.
Sys Cap Supported/Enabled : bridge,router/bridge
port-string (Optional) Displays local system information for one or a range of
ports.