Using the Command Line Interface
1-6 Introduction
Using the Command Line Interface
Starting a CLI Session
Connecting Using the Console Port
Connect a terminal to the local console port as described in your Enterasys C3 Installation Guide.
The startup screen, Figure 1-1, will display on the terminal. You can now start the Command Line
Interface (CLI) by
• using a default user account, as described in “Using a Default User Account” on page 1-7, or
• using an administratively-assigned user account as described in “Using an Administratively
Configured User Account” on page 1-7.
Figure 1-1 Enterasys C3 Startup Screen
Connecting Using Telnet
Once the Enterasys C3 device has a valid IP address, you can establish a Telnet session from any
TCP/IP based node on the network. For information about setting the switch’s IP address, refer to
“set ip address” on page 3-4.
Split horizon Enabled for RIP packets without poison reverse.
Stub area (OSPF) None configured.
Timers (OSPF) SPF delay set to 5 seconds. SPF holdtime set to 10 seconds.
Transmit delay (OSPF) Set to 1 second.
VRRP Disabled.
Table 1-2 Default Settings for Router Operation (Continued)
Feature Default Setting
Username:admin
Password:
Enterasys C3
Command Line Interface
Enterasys Networks, Inc.
50 Minuteman Rd.
Andover, MA 01810-1008 U.S.A.
Phone: +1 978 684 1000
E-mail: support@enterasys.com
WWW: http://www.enterasys.com
(c) Copyright Enterasys Networks, Inc. 2012
Chassis Serial Number: 041800249041
Chassis Firmware Revision: 6.61.xx.xxxx
C3(su)->
To Next Page
Loading...
