Enterasys C3G124-24 - Show Vlan Association

show vlan association
14-28 802.1Q VLAN Configuration
Defaults
If no optional parameter is specified, all VLAN associations are cleared.
If mac is specified but no MAC address is specified, all MAC VLAN associations are cleared.
If subnet is specified but no IP address and mask is specified, all IP subnet VLAN associations are
cleared.
If protocol is specified but no protocols are specified, all protocol VLAN associations are cleared.
Mode
Switch command, read-write.
Example
This example clears all MAC VLAN associations.
C3(su)->clear vlan association mac
show vlan association
Use this command to display configured VLAN associations.
Syntax
show vlan association [mac] | [subnet} | [protocol]
Parameters
Defaults
If no optional parameter is specified, all configured VLAN associations are displayed.
Mode
Switch mode, read-only.
subnet [ip-addr ip-
mask ]
(Optional) Specifies the IP address and subnet mask for the VLAN
association to clear.
If no subnet address and mask are specified, all subnet VLAN
associations are cleared.
protocol [protocol-list] (Optional) Specifies the protocol or list of protocols for the VLAN
association to clear. Specify the protocols by keyword or hexadecimal or
decimal values, separated by commas (,).
Keywords can be: arp, ip, or ipx.
Hexidecimal or decimal values can be in the range of 0x0600(1536) to
0xFFFF(65535).
If no protocol is specified, all protocol VLAN associations are cleared.
mac (Optional) Display MAC VLAN associations.
subnet (Optional) Display IP subnet VLAN associations.
protocol (Optional) Display protocol VLAN associations.