set sntp authentication-key Configuring SNTP
Enterasys C3 Configuration Guide 20-13
Parameters
Defaults
SNTP authentication is disabled by default.
Mode
Switch command, read-write.
Examples
The following example enables SNTP authentication on the switch.
C3(su)->set sntp authenticate enable
The following example configures the switch SNTP client for authentication by configuring two
authentication keys and adding them to the trusted key list, then enabling authentication on the
switch, and finally, configuring one of the SNTP/NTP servers to use one of the keys.
C3(su)->set sntp authentication-key 1 md5 mykey
C3(su)->set sntp trusted-key 1
C3(su)->set sntp authentication-key 2 md5 keytwo
C3(su)->set sntp trusted-key 2
C3(su)->set sntp authenticate
C3(su)->set sntp client unicast
C3(su)->set sntp server 192.168.10.10 key 1 precedence 1
set sntp authentication-key
Use this command to configure an authentication key entry. A maximum of five entries can be
configured.
Syntax
set sntp authentication-key key-id md5 key-value
Parameters
Defaults
None.
enable | disable Enable or disable SNTP authentication on the switch.
Authentication is disabled by default.
key-id Specifies the ID number for this key entry. Valid range is from 1 to
4294967295, although only a maximum of 5 entries can be configured.
md5 Specifies MD5 as the encryption algorithm to be used for SNTP
authentication.
key-value Specifies the value of the key, which is the authentication password.
Password string can be from 1 to 32 characters in length.
To Next Page
Loading...
