Enterasys C3G124-24 - Setting Speed and Duplex Mode; Purpose; Commands; Show Port Speed

Setting Speed and Duplex Mode
11-10 Port Configuration
Setting Speed and Duplex Mode
Purpose
To review and set the operational speed in Mbps and the default duplex mode: Half, for half
duplex, or Full, for full duplex for one or more ports.
Commands
show port speed
Use this command to display the default speed setting on one or more ports.
Syntax
show port speed [port-string]
Parameters
Defaults
If port-string is not specified, default speed settings for all ports will display.
Mode
Switch command, read-only.
Example
This example shows how to display the default speed setting for Ethernet port 14 in unit 3:
C3(su)->show port speed ge.3.14
default speed is 10 on port ge.3.14.
Note: These settings only take effect on ports that have auto-negotiation disabled.
For information about... Refer to page...
show port speed 11-10
set port speed 11-11
show port duplex 11-11
set port duplex 11-15
port-string (Optional) Displays default speed setting(s) for specific port(s). For a
detailed description of possible port-string values, refer to “Port String
Syntax Used in the CLI” on page 11-1.