set snmp user
12-8 SNMP Configuration
If user is not specified, information about all SNMP users will be displayed.
If remote is not specified, user information about the local SNMP engine will be displayed.
If a storage type is not specified, user information for all storage types will be displayed.
Mode
Switch command, read-only.
Examples
This example shows how to display an SNMP user list:
C3(su)->show snmp user list
--- SNMP user information ---
--- List of registered users:
Guest
admin1
admin2
netops
This example shows how to display information for the SNMP “guest” user:
(su)->show snmp user guest
--- SNMP user information ---
EngineId: 00:00:00:63:00:00:00:a1:00:00:00:00
Username = Guest
Auth protocol = usmNoAuthProtocol
Privacy protocol = usmNoPrivProtocol
Storage type = nonVolatile
Row status = active
Table 12-3 provides an explanation of the command output.
set snmp user
Use this command to create a new SNMPv3 user.
Syntax
set snmp user user [remote remoteid] [encryption {des | aes}] [privacy
privpassword] [authentication {md5 | sha}] [authpassword] [volatile | nonvolatile]
Table 12-3 show snmp user Output Details
Output Field What It Displays...
EngineId SNMP local engine identifier.
Username SNMPv1 or v2 community name or SNMPv3 user name.
Auth protocol Type of authentication protocol applied to this user.
Privacy protocol Type of encryption protocol applied to this user.
Storage type Whether entry is stored in volatile, nonvolatile or read-only memory.
Row status Status of this entry: active, notInService, or notReady.
To Next Page
Loading...
Need help?
General