Enterasys C3 Configuration Guide 15-1
15
Policy Classification Configuration
This chapter describes the Policy Classification set of commands and how to use them.
Policy Classification Configuration Summary
Enterasys C3 devices support policy profile-based provisioning of network resources by allowing
IT administrators to:
• Create, change or remove policy profiles based on business-specific use of network services.
• Permit or deny access to specific services by creating classification rules that filter on a
protocol basis and assign the traffic to a particular VLAN or Class of Service (CoS). You can
then assign these rules to a user profile.
• Assign or unassign ports to policy profiles so that only ports activated for a profile will be
allowed to transmit frames accordingly.
For information about... Refer to page...
Policy Classification Configuration Summary 15-1
Configuring Policy Profiles 15-2
Configuring Classification Rules 15-6
Assigning Ports to Policy Profiles 15-15
Configuring Policy Class of Service (CoS) 15-18
Note: An Enterasys Networks Feature Guide document containing an in-depth discussion of Policy
configuration is located on the Enterasys Networks web site:
https://extranet.enterasys.com/downloads/
Note: It is recommended that you use Enterasys Networks NetSight Policy Manager as an
alternative to CLI for configuring policy classification on the Enterasys C3 devices.
To Next Page
Loading...
