Packet Capture Commands
Enterasys C3 Configuration Guide 21-21
Packet Capture Commands
Note that packet capture filter is sampling only and does not guarantee receipt of back-to-back
packets.
Purpose
To display RMON capture entries, configure, enable, or disable capture entries, and clear capture
entries.
Commands
show rmon capture
Use this command to display RMON capture entries and associated buffer control entries.
Syntax
show rmon capture [index [nodata]]
Parameters
Defaults
If no options are specified, all buffer control entries and associated captured packets will be
displayed.
Mode
Switch command, read-only.
Example
This example shows how to display RMON capture entries and associated buffer entries:
C3(rw)->show rmon capture
Buf.control= 28062 Channel= 38283 EntryStatus= valid
----------------------------------------------------------
FullStatus avail FullAction lock
Captured packets 251 Capture slice 1518
Download size 100 Download offset 0
Max Octet Requested 50000 Max Octet Granted 50000
Start time 1 days 0 hours 51 minutes 15 seconds
For information about... Refer to page...
show rmon capture 21-21
set rmon capture 21-22
clear rmon capture 21-23
index (Optional) Displays the specified buffer control entry and all captured
packets associated with that entry.
nodata (Optional) Displays only the buffer control entry specified by index.
To Next Page
Loading...
Need help?
General