Enterasys C3G124-24 - Setting the Host VLAN; Commands; Purpose; Set Host Vlan

Setting the Host VLAN
14-18 802.1Q VLAN Configuration
Setting the Host VLAN
Purpose
To configure a host VLAN that only select devices are allowed to access. This secures the host port
for management-only tasks.
Commands
show host vlan
Use this command to display the current host VLAN.
Syntax
show host vlan
Parameters
None.
Defaults
None.
Mode
Switch command, read-only.
Example
This example shows how to display the host VLAN:
C3(su)->show host vlan
Host vlan is 7.
set host vlan
Use this command to assign host status to a VLAN.
Syntax
set host vlan vlan-id
Note: The host port is the management entity of the device. Refer to “Creating a Secure
Management VLAN” on page 14-2 for more information.
For information about... Refer to page...
show host vlan 14-18
set host vlan 14-18
clear host vlan 14-19