Enterasys C3G124-24 - Set Switch; Show Switch Stack-Ports

show switch stack-ports
2-8 Configuring Switches in a Stack
Supported Cards:
Slot 0
Card Index (CID) 1
Model Identifier C2G124-24
show switch stack-ports
Use this command to display various data flow and error counters on stack ports.
Syntax
show switch stack-ports [unit]
Parameters
Defaults
None.
Mode
Switch command, read-only.
Usage
If a stacking port has been configured to use a 5 meter stacking cable with the set switch stack-
ports length command, 5m will be displayed in the Stacking Port column next to the port
descriptor (Up or Down).
Example
This example shows how to display data and error information on stack ports:
C3(ro)->show switch stack-ports
------------TX-------------- ------------RX-----------
Data Error Data Error
Stacking Rate Rate Total Rate Rate Total
Switch Port (Mb/s) (Errors/s) Errors (Mb/s) (Errors/s) Errors
------ ---------- ------ ---------- ---------- ------ ---------- --------
1 Up 0 0 0 0 0 0
Down 0 0 0 0 0 0
set switch
Use this command to assign a switch ID, to set a switch’s priority for becoming the management
switch if the previous management switch fails, or to change the switch unit ID for a switch in the
stack.
Syntax
set switch {unit [priority value | renumber newunit]}
unit (Optional) Specifies the switch unit ID, an integer ranging from 1 to 8.