Enterasys C3G124-24 - Configuring Policy Profiles

Configuring Policy Profiles
15-2 Policy Classification Configuration
Configuring Policy Profiles
Purpose
To review, create, change and remove user profiles that relate to business-driven policies for
managing network resources.
Commands
show policy profile
Use this command to display policy profile information.
Syntax
show policy profile {all | profile-index [consecutive-pids] [-verbose]}
Parameters
Defaults
If optional parameters are not specified, summary information will be displayed for the specified
index or all indices.
Mode
Switch command, read-only.
Example
This example shows how to display policy information for profile 11:
C3(su)->show policy profile 11
Profile Index : 11
Profile Name : Auth1
Row Status : active
Port VID Status : Enable
Port VID Override : 11
CoS : 0
Note: This device supports profile-based CoS traffic rate limiting only. Policy rules specifying CoS
will not support inbound rate limiting.
For information about... Refer to page...
show policy profile 15-2
set policy profile 15-3
clear policy profile 15-5
all | profile-index Displays policy information for all profile indexes or a specific profile index.
consecutive-pids (Optional) Displays information for specified consecutive profile indexes.
-verbose (Optional) Displays detailed information.